Physitemp-instruments NTE2A Thermal Sensitivity Tester Manuel d'utilisateur télécharger pdf (Page 7)

CONTROLLER SPECIFICATIONS

BASE TEMPERATURE RANGE Continuously adjustable over range 20 - 30 C with flat

bladed screwdriver

CONTROL RANGE 20.5either side of nominal base temperature point in

switchable 0.1 steps. 45 C max.

CONTROL ACCURACY 0.1 C

DIGITAL READOUT: Resolution 0.1 C

Accuracy 0.1,  digit

AMBIENT OPERATING RANGE 15 - 45 C

INPUT POWER REQUIREMENTS 100 - 120V AC, 60Hz, 100W

200 - 240V AC, 50Hz, 100W

SIZE 8" high x 7" wide x 15" deep

WEIGHT 28 lbs

OTHER FEATURES Spring loaded switch indication of set-point Safety

shutdown with warning lamp in case of fault condition

such as thermocouple sensor breakage, lack of cooling

water or electronics failure. Self-sealing water connectors.

Auxiliary AC switched output.

THERMAL PROBE SPECIFICATIONS

SIZE 6.5” long x 5/8” dia. Total length with cable, 6 feet approx

WEIGHT 0.5 lb

TEMPERATURE CONTROLLED 0.5” diameter

SURFACE AREA

RANGE 0 - 45 C

Note: Sustained exposure to temperatures over 46 C can

cause burns. This equipment is not intended for use at

temperatures over 45 C

RESPONSE TIME Less than 4 seconds in heating or cooling

OTHER FEATURES Built-in feedback sensor, type T, copper-constantan.

Self sealing water connectors.

5.0 WARRANTY AND SERVICE

1 2 3 4 5 6 7 8

Pas de commentaire

Physitemp-instruments NTE2A Thermal Sensitivity Tester Manuel d'utilisateur Page 7