Physitemp-instruments NTE2A Thermal Sensitivity Tester Manuel d'utilisateur télécharger pdf (Page 4)

2.3 ATTACHING THE LINE CORD

BEFORE CONNECTING CONTROLLER TO AC POWER SUPPLY CHECK THE

SETTING OF THE VOLTAGE SELECTOR MODULE.

This module is on the back panel, bottom left. There are four settings. Be sure selector is set

for your power requirements. A red indicator should be visible beside the correct voltage in

the list printed on the fuse cover. If the red indicator does not mark the correct voltage, the

card inside the fuse case must be pulled out and reinserted with the proper orientation.

Please note: The controller can be set to 120V or 240V.However the pump and tank unit

does not have voltage setting adjustments. Use PTU-110A for 110/120V and PTU-220 for

220/240V operation.

2.4 ATTACHING WATER TUBES

The Pump and Tank Unit is supplied with two

water tubes. All connections are self-sealing

when disconnected to prevent water spills.

To connect, push in firmly. Squeeze to

disconnect.

Connect one of the tubes from the OUTLET of pump to water INLET on the back panel of

the controller.

Connect the second tube from RETURN of pump to water OUTLET on the controller.

2.5 CONNECTING THE THERMAL PROBE

1 2 3 4 5 6 7 8

Pas de commentaire

Physitemp-instruments NTE2A Thermal Sensitivity Tester Manuel d'utilisateur Page 4